PowerFlex Fence Project :: Day One

We have started! I can’t tell you how great it is to actually say those words and see the progress as we get work done. Gary Duncan showed up yesterday morning with a truck load of materials and the know-how to get this fence going! Shortly after that my Uncle Loren pulled in with a tractor (my cousin Verne had also brought a tractor and post-hole digger Monday), a mower, and a bunch of tools. Before I knew it corner posts and wood transition posts were going in the ground and by the end of the evening we even had our first PowerFlex posts up on the perimeter.

In the picture above you can see Mr. Duncan teaching me how to tie a wire knot. Let me just tell you that it is one cool little trick. This is the process that he uses to tie the insulators to the wood posts and to tie the line wire to the insulator. In other places he used a crimp sleeve to make the loop. He is doing different things in different places so that I can get an idea of what is possible, but I have to say the wire knots seem the best because you don’t really need any tools. Check out this link to go to a little article that explains the process.

This picture shows what much of my day involved. We had to put in the corner posts and line posts in order to start stringing the wire so there was a lot of digging to do. As you can see the John Deere 4020 and post hole digger came in handy. But, there was still some hand digging to do in order to get the posts deep enough. We are pretty much done with the perimeter posts, but there are a couple brace posts that need to go in yet. Today we are going to be focusing on putting in the posts along the woods. This will be a three wire fence so our bracing won’t need to be as stout, but Mr. Duncan also pointed out that we could easily add a floating brace in the future if we needed to … you can read about floating braces on the PowerFlex page at this link.

Finally, as I mentioned we even have the PowerFlex posts up on the first stretch of fence. In this picture you can see Mr. Duncan pounding in a post with a regular steel post driver. If you look really closely in the picture (you can click on it to enlarge it) you can see a blue thing sticking out of the ground just past the wood post in the picture. This is a tool that he used to make a pilot hole and then would pound in the post. He said we could just pound the posts in without the pilot hole, but he liked to do it this way because it helped get them in the ground straight.

Of course, chime in with any questions you have about the process and I’ll make sure to take some time to answer (after asking Mr. Duncan of course!). Check back tomorrow for another update!